To Next PageTo Next PageHow to fix Furuno FAR-2318 Marine Radar when the picture is not updated or frozen?
If the picture on your Furuno Marine Radar is not updating or is frozen, it could be due to the Rotary Encoder inside the antenna unit, the SPU board inside the antenna, or a video freeze-up. Try checking the connection of signal cables, replacing the SPU board, or turning the radar off and then on again.
Why does my Furuno FAR-2318 Marine Radar have poor sensitivity after tuning?
If your Furuno Marine Radar has poor sensitivity after tuning, it could be due to the second trace echo rejector being on or dirt on the radiator face. Try disabling the second trace echo rejector and cleaning the radiator face.
Why are range rings not displayed on my Furuno FAR-2318 Marine Radar?
If range rings are not displayed on your Furuno Marine Radar, one possibility is to adjust the brilliance of range rings on the BRILL menu to see if intensity is increased. If this is unsuccessful, consider replacing the associated circuit board or the MAIN board.
What to do if Furuno FAR-2318 picture is not updated or freezes?
If the picture on your Furuno Marine Radar is not updating or is frozen, the issue might be a video freeze. Turn the power off and on again to restore normal operation.
What causes marks, indications, and noise but no echo on Furuno FAR-2318 Marine Radar?
If you are seeing marks, indications, and noise but no echo on your Furuno Marine Radar, the Tx high voltage protection circuit may have activated. Reset the power to restore normal operation.
How to display range rings on Furuno FAR-2318?
If range rings are not displayed on your Furuno Marine Radar, it may be because they are turned off. Try turning on the range rings with [RANGE RING] in the [NAVTOOL] menu. If they still do not appear, their brilliance may be too low; adjust their brilliance in the [BRILL] menu.
Why is my Furuno Marine Radar properly tuned but has poor sensitivity?
If your Furuno Marine Radar is properly tuned but has poor sensitivity, possible causes include a deteriorated magnetron, a detuned MIC, dirt on the radiator face, water ingress to the waveguide or other feeder line, or the second trace echo rejection being active. Consider the following: 1. Check magnetron current with the radar transmitting on 48 nm range. If the current is below normal, the magnetron may be defective and need replacement. 2. Check the MIC detecting current. If it is below the normal value, the MIC may have become detuned and needs tuning. 3. Clean the radiator surface. 4. Remove water from the feeder line. 5. Disable the second-trace echo rejector.
How to fix Furuno FAR-2318 Marine Radar if it cannot turn on?
If your Furuno Marine Radar cannot turn on, the possible causes are: a blown fuse, issues with the mains voltage/polarity, or a problem with the power supply board (PWR1 and/or PWR2) inside the Processor unit. To resolve this: * Replace the blown fuse. * Correct the wiring and input voltage. * Replace the faulty power supply board.
What causes poor discrimination in range on Furuno Marine Radar?
General| Brand | Furuno |
|---|---|
| Model | FAR-2318 |
| Category | Marine Radar |
| Language | English |
