6.1 Self-test
6-8
Key check
Key check is a function for checking the panel keys.
The drawing on the left below corresponds to the arrangement of the keys, knobs and
trackball of RCU-014 and the drawing on the right corresponds to those of RCU-015
and RCU-016 (but the power key is excluded.)
The boxes numerically displayed are used for checking of the knobs and track ball
showing changes in a range between 0 and 255. Other boxes correspond to keys and the
corresponding key is highlighted when a box is pressed.
Fig. 6.1.6 RCU-014 Key Check
When the Trackball control unit RCU-015 is connected with the Remote control unit
RCU-016, both units use the display on the right. The left-side display is not used.
Fig. 6.1.7 RCU-015 and 016 Key Check
000 000 0 0
0
0
28
88
Press the [F1] key 2 times
to go to the next test.
RCU-016
Excluding the Power key.
RCU-014
RPU-015
RPU-016
To Next Page
Loading...
