Why is there noise and interference on my Furuno Marine Equipment?
If you are experiencing noise and interference with your Furuno Marine Equipment, ensure that the GAIN and CLUTTER settings are properly adjusted. Also, verify the setting of the noise limiter and check the equipment’s ground.
What to do if there is no depth readout on Furuno FCV-1200L?
If you are not getting a depth readout on your Furuno Marine Equipment, verify that the bottom is present on the normal picture range. Also, check if the bottom echo is strong enough, appearing as red or reddish-brown in color.
Why is the bottom traced in zigzag pattern on Furuno FCV-1200L Marine Equipment?
If the bottom is traced in a zigzag pattern or you experience occasional loss of echo with your Furuno Marine Equipment, it may be because the sea is rough. The bottom is traced zigzag when the sea is rough. Another cause may be that your boat has passed over another boat’s wake, which blocks the propagation of sound waves.
What to do if automatic shift is inoperative on Furuno Marine Equipment?
If the automatic shift is inoperative on your Furuno Marine Equipment, check if the bottom echo is strong enough, appearing as red or reddish brown in color.
Why is the picture distorted on my Furuno FCV-1200L Marine Equipment?
If the picture appears distorted on your Furuno Marine Equipment, check if any magnetic field generating equipment, such as transformers or rectifiers, are nearby.
How to check for low sensitivity on Furuno Marine Equipment?
If you suspect low sensitivity with your Furuno Marine Equipment, check that the gain control is properly set.
Why is the color strange in a given area on Furuno FCV-1200L?
If the color appears strange in a given area on your Furuno Marine Equipment, check if a magnet is near the equipment.
Why is occasional noise seen on Furuno FCV-1200L Marine Equipment?
If you see occasional noise on your Furuno Marine Equipment, check if the cables of pulse generating equipment are near the equipment.
What to do if there are no echoes but the scale appears on Furuno FCV-1200L Marine Equipment?
If there are no echoes but the scale appears on your Furuno Marine Equipment, check if the transducer is properly connected.
How to fix no zero line on Furuno FCV-1200L Marine Equipment?
If there is no zero line, or the zero line is not in the correct position on your Furuno Marine Equipment, check if the range is shifted, as the zero line does not appear when the range is shifted. You can also press the [-] key so that the scale appears from 0.
General| Display Size | 12.1 inches |
|---|---|
| Frequency | 50/200 kHz |
| Waterproof Rating | IPX6 |
| Power Supply | 12/24 V DC |
| Operating Temperature | -15°C to +55°C |
| Category | Fish Finder |
| Display Type | Color LCD |
| Resolution | 800 x 600 pixels |
| Power Output | 1 kW |
| Depth Range | Up to 1000 meters |
To Next Page
