Furuno FS-1575 - Goto Line Navigation; Goto Top;Bottom of File

10-1
10. NBDP TRANSMISSION,
RECEPTION
This chapter mainly shows you how to transmit and receive telex messages.
10.1 Manual Calling
The simplest way to communicate with a telex subscriber is manual calling. For the
ARQ mode, you can display beforehand the message to send, or type your message
manually.
1. Press the function key F3 to open the [Operate] menu.
2. For IB-583:
Press the 9 key to select [Set Frequency].
Before calling, watch the intended TX
frequency carefully to confirm that is
unoccupied.
NOTICE
1: Call Station
3: File to Send
4: Cancel Sending
5: Scan (Start/Stop)
6: Manual Reception
7: Timer Operation
8: Manual Calling
9: Set Frequency
Operate
2: Macro Operation
1: Call Station
3: File to Send
4: Cancel Sending
5: Scan (Start/Stop)
6: Manual Reception
7: Timer Operation
8: Manual Calling
9: Set Frequency
0: Set Channel
Operate
2: Macro Operation
For IB-583
For IB-585
Set Frequency
Tx Freq: 0.00
RX Freq: 0.00