Furuno FS-1575 - Sound Settings

6. MENU OPERATION
6-19
6. Rotate the ENTER knob to select [DIRECT INPUT] or [ADDRESS BOOK DATA]
then push the knob.
[ADDRESS BOOK DATA]: Select an MMSI from the [ADDRESS BOOK] (see
section 6.15) then push the ENTER knob.
[DIRECT INPUT]: Enter MMSI of coast station (seven digits) with the numeric
keys then push the ENTER knob.
7. With [TEL] selected, push the ENTER knob.
8. Enter the telephone no. (up to 16 digits) with the numeric keys then push the EN-
TER knob.
9. With [DSC FREQ] selected, push the ENTER knob.
10. Rotate the ENTER knob to select DSC frequency referring to "How to set DSC fre-
quency" on page 5-2 then push the knob.
11. With [FILE NAME] selected, push the ENTER knob.
12. Enter the file name (max. 20 letters) with the numeric keys.
13. With [REGISTER] selected, push the ENTER knob.
6.16.5 Test call
1. Open the [MESSAGE FILE] list.
2. Press the 5 key to open the [MESSAGE FILE ENTRY] screen.
3. With [MSG TYPE] selected, push the ENTER knob.
4. Rotate the ENTER knob to select [TEST MSG] then push the knob.
5. With [TO] selected, push the ENTER knob.
6. Rotate the ENTER knob to select [DIRECT INPUT] or [ADDRESS BOOK DATA]
then push the knob.
[ADDRESS BOOK DATA]: Select an MMSI from the [ADDRESS BOOK] (see
section 6.15) then push the ENTER knob.
[DIRECT INPUT]: Enter the MMSI where to send the test message with the nu-
meric keys then push the ENTER knob.
7. With [DSC FREQ] selected, push the ENTER knob.
8. Rotate the ENTER knob to select DSC frequency desired then push the knob.
9. With [FILE NAME] selected, push the ENTER knob.
10. Enter the file name (max. 20 letters) with the numeric keys.
11. With [REGISTER] selected, push the ENTER knob.
6.16.6 How to edit prepared messages
1. Open the [MESSAGE FILE] list.
2. Rotate the ENTER knob to select the message file to edit then push the knob.