11. MAINTENANCE & TROUBLESHOOTING
11-8
Scan group by that name does
not exist.
The scan group under this
name does not exist.
Check the scan group name.
Scan group memory is full. The scan group memory is full. Delete unnecessary scan
groups.
Channel by that number does
not exist.
The channel number does not
exist.
Check the channel number.
Operation name already exists. The timer operation under this
name has already existed.
Change the timer operation
name.
Timer operation memory is full. The timer operation memory is
full.
Delete unnecessary timer oper-
ations.
Device Access Error The device access fails. The data can be corrupted be-
cause picking up the SD card
on access. Before picking up
the SD card, execute [Remove
SD Card] from the [File] menu.
File Write Error (Write Protect-
ing)
The writing on the file fails. The
file is write-protect status.
Awake the write-protect for the
SD card.
File Open Error (Already
Opened)
The file is already opened. -
File Open Error (Max Open) The number of the opened files
is over the specified number.
Close an opened file.
File Open Error (File not Found) The file does not exist. Check the file name.
File Open Error (File Exist) The file has already existed. Change the file name.
SD Card Format failed. The format of the SD card fails. Check the SD card.
File not found. ’%s’ The file is not found. (’%s’
means the file name.)
Check the file name.
Card full. The capacity of the SD card is
full.
Change the SD card or delete
unnecessary files.
Check interconnections be-
tween terminal and Main. Set
SMT for stand-alone use.
Check the connection between
the terminal unit and the trans-
ceiver unit. Set the SMT for the
stand-alone use.
Check if the transceiver unit
turns on. Check the connction
between the terminal unit and
the transceiver unit. For the
stand-alone use for IB-585, set
the time in the [System] menu.
Cannot print. Check connection
between printer and terminal
Can not print out. Check the
connection between the printer
and the terminal unit.
Check the connection between
the printer and the terminal unit.
Selected file is not macro. The selected file is not a macro
file.
Select a file with ".mcr" exten-
sion.
Macro command error. The macro command is illegal. Check the macro command.
Wait one minute before calling
again after failed
When failing to call, wait a
minute before calling again. In
case of automatic disconnec-
tion because of no replay from
the called party during calling in
the ARQ mode, can not call
again for a minute.
-
OCCUPIED. The transceiver unit has priori-
ty.
Can not operate the NBDP ter-
minal unit because of in opera-
tion of the transceiver unit.
Switch the transceiver unit to
the RT screen.
Notification message Meaning Remedy
To Next Page
Loading...
