Furuno MCU-004 Sales Bulletin

6
2-3 Cross Cursor
While the cursor is operated with the joystick, a cross cursor is shown on the screen.
Cursor Speed Adjustment
Cross Cursor on Screen
The cursor speed is adjustable in menu.
[Menu] (TZT9/14/BB) / [Settings] (TZTL12F/15F) –
[General] – [Cross Cursor Speed]
2-4 General Limitations and Notes
(1) Limitation in Drag by Joystick
The joystick has NO “drag” function. The guard zone setting
of Radar, which requires to be adjusted by drag, will not be
available with the MCU-004 joystick. This operation should be
made by touch operations or with a generic mouse/trackball
unit.
(2) Limitation in 3D Mode – Pan/Tilt
You can turn the screen mode into the 3D mode by selecting
[3D Mode] from the contextual menu. However, you cannot
pan/tilt the chart with the MCU-004 because sliding the
screen with two fingers is the only way to pan/tilt it. The chart
in 3D is always in the default angle as shown at right. Or if you
have paned/tilted the chart with two fingers before, the
screen will be in the previously set angle.

Furuno MCU-004 Specifications

General

Brand	Furuno
Model	MCU-004
Category	Control Unit
Language	English