PLEASE READ BEFORE UPDATING SOFTWARE IN YOUR
NAVNET TZTOUCH2 MFD
Only update software while in port, never while underway. Do not attempt
to update the software the same day you are planning on using the
equipment.
Software version 6.21 update requires a reset to the internal sounder as
well as a Master Reset to the MFD. You need to save all valuable user
data prior to updating the software, such as; waypoints, routes, tracks
and user settings. Instructions for saving user data can be found in
chapter 8 of the Operator’s Manual, chapter 6 of the onboard eGuide, and
in the NavNet TZtouch2 Exporting and Importing Points, Routes, Tracks,
and Settings document found in the manuals sections of the TZTL12F and
15F.
This update should be done with any additional MFDs turned off.
Note: Total time for the software update is approximately 30 minutes
1. Download the software from the Furuno website to a folder on your
desktop.
2. Once you download the Zip file from the Furuno USA website you will
need to extract it. Once extracted, the result will look like the picture
below (containing two folders).
When you open the first file, Part 1 containing the updated OS
(operating system) and App (application) you will see the contents
below.
3. Transfer these files to the root directory of a formatted (not to exceed
32GB) micro SD card. There should be nothing else on the micro SD
To Next Page
Loading...
