Furuno RD-30 Operator's Guide

RD-30 MULTI DISPLAY
Operator’s Guide
The purpose of this Operator's Guide is to provide basic operating procedures for this
equipment. For more detailed information see the Operator's Manual.
MENU
PWR
*
ENT
DISP
DIM
FURUNO
RD-30

1
2
4
5
6
7
3
3 Registers menu options.
2 Shifts highlight cursor.
1 Opens/closes the menu.
4 Adjust key backlighting; display contrast.
5 Turns power on/off.
6 Displays RX data.
7 Selects a display.
Turning the Power On/Off
Press the [PWR] switch.
Adjusting Panel Dimmer,
Display Contrast
1. Press the [DIM] key.
DIMMER (1~8)
CONTRAST (0~63)
▲
▼
4
45
EXIT:[ENT]
▲
▼
2. Press up or down arrow to adjust panel
dimmer; left or right arrow to adjust
display contrast.
3. Press the [ENT] key to finish.
Choosing a Display
Press the [DISP] key.
Choosing Display Type
1. Press the [MENU] key once or twice.
MAIN MENU
USER DISP
ALARM1
ALARM2
MESSAGES
RESET
OFFSETS
SYS SETUP
I/O SETUP
TD SETUP
LANGUAGE
UNITS
HDG SETUP
2. Choose USER DISP and press the [ENT]
key.
USER DISPLAY SETUP
1: DIGITAL
2: DIGITAL
3: DIGITAL
4: DIGITAL
5: DIGITAL
3. Use the cursor pad to choose display
number and press the [ENT] key.
DIGITAL
GRAPH
GRAPHIC
HIGHWAY
DIGITAL
GRAPH
GRAPHIC
HIGHWAY
OFF
#1 display
#2-#5 displays
4. Choose display type desired and press
the [ENT] key.
5. Press the [MENU] key twice to close the
menu.

Furuno RD-30 Specifications

General

Brand	Furuno
Model	RD-30
Category	Monitor
Language	English