25
Priority setup
1. Press ▲ or ▼ to choose SET PRIORITY at the SET I/O PORT sub-menu and
press the [ENT] key.
[SET PRIORITY]
L/L, COG, SOG
HDG
ROT
QUIT [MENU]
PRIORITY menu
2. "L/L, COG, SOG" is selected; press the [ENT] key.
[SET L/L, COG, SOG]
COM4: 1
COM5: 2
COM6: 3
QUIT [MENU]
3. COM4 is selected; press the [ENT] key to display the setting window.
1
2
3
4. Choose the priority level for the COM4 port (position, course over ground and
speed over ground data) and press the [ENT] key.
"1" is the highest and "3" is the lowest.
5. Set the priority of COM5 and COM6 similarly.
Note: Do not set same number among COM4, COM5 and COM6.
6. Press the [MENU] key to return to the SET PRIORITY menu.
7. Press ▲ or ▼ to choose HDG and press the [ENT] key.
8. Set the priority for heading data similar to how you did for “L/L, COG, SOG”.
9. Press ▲ or ▼ to choose ROT and press the [ENT] key.
10. Set the priority for rate-of-turn data similarly.
11. Press the [MENU] key several times to save the settings.
To Next Page
Loading...
