8
AUDIO FUNCTIONS
All Audio functions are easily accessable on the
RV-CD850BT.
AUDIO MENU. Press the ENCODER VOLUME CONTROL to access the
Audio Menu mode. Then press ENTER or TUNE UP to
select the Audio Function to be adjusted, then rotate the
ENCODER VOLUME CONTROL to select the desired setting. You can
always return to the previous Audio Function by pressing
the TUNE DOWN button.
REMINDER
In the AUDIO MENU, or in any menu, you can quickly exit the
menu by pressing the ESC/END button
QUASI-PARAMETRIC FUNCTION ā CFQ ADJUSTMENT
As part of the available Audio Functions, you have
the ability to adjust the Center Frequency of the Bass,
Midrange or Treble controls. This gives you greater
control of the adjustment of these functions by allowing
you to select the preferred Center Frequency to adjust.
If you are unsure of which CFQ settings to use, please use
the following Default settings: Bass CFQ 80Hz, Midrange
CFQ 1.5K Hz & Treble CFQ 12.5K Hz
AUDIO FUNCTION ADJUSTMENT:
EBX ON/OFF: Turn ON or OFF the EBX (Encounter Bass
Xtender) Bass Boost.
BAS Adjust the Bass level between -7 to +7.
BAS CFQ Select Bass centre frequency: 60 / 80 / 100 / 200Hz
MID Adjust the Midrange level between -7 to +7.
MID CFQ Select the Midrange centre frequency: 0.5K /
1.0K / 1.5K / 2.5KHz
TRE Adjust the Treble level between -7 to +7.
TRE CFQ Select the Treble centre frequency: 10.0K /
12.5K / 15.0K / 17.5KHz
BAL (Balance) Adjust the balance between the right and left
speakers from 12R (full right) to 12L (full left).
ZONE FADER Adjust the fader between the internal and
external speakers from 12INT (full internal) to
12EXT (full external).
EQUALISER OPERATION
When you activate the Equaliser, the Pre-Set Equaliser
settings override your existing Bass, Midrange & Treble
Settings.
Press the Equaliser button repeatedly to cycle through
the following pre-sets: FLAT->POP->USER->DANCE-
>ROCK->CLASSIC->JAZZ->VOCAL
To return to the Bass/Midrange/Treble settings that were
in use before the EQ was selected, please select the USER
setting.