FUTABA 10CAG - Page 116

116
VSHFL¿FSHDNFKDUJLQJUHTXLUHPHQWV>5HTXLUHD]HURGHOWDSHDNFKDUJHUODEHOHGVSHFL¿FDOO\IRUXVHZLWK1L0+EDWWHULHV@
NORMAL
: trainer mode that does not give student radio the computer programming features of the master radio. See
Trainer.
NT8S: standard transmitter battery pack. See Accessories.
NULL
: not assigned or never changed. Ex: a mix which has a null switch assignment is always active, and can never be
FKDQJHGLQÀLJKWWXUQHGRIIQRPDWWHUZKLFKVZLWFKLVPRYHG
OFFSET
: (
HELI
) separate trim settings available to each idle-up (using
CONDITION
) setting, or assigned to separate switches
from the condition switches. When offset is
ON
, movement of the trim levers adjusts the
OFFSET
, not the normal condition's
trims. .................................................................................................................................................................................. 102
OFFSETs
DGGLWLRQDOÀLJKWFRQGLWLRQVDYDLODEOHVSHFLI¿FDOO\IRUVDLOSODQHV ......................................................................... 84
Offset mix: mix that independently moves the slave servo a set percentage of its total throw, not in relation to any master.
See Programmable mix.
PA2: Pilot Assist. Optional onboard device that uses optical sensors to correct modelis orientation to upright.
PARAMETER
VXEPHQXVHWVVSHFL¿FSDUDPHWHUV,QFOXGHVUHVHWW\SHPRGXODWLRQVHFRQGDLOHURQVHUYRVHWXSDQG
ATL
. ... 33
Peak Charger: charger that automatically stops charging when the battery is fully charged (commonly called "peaked").
See Battery care and charging.
Piezo gyro: gyro that uses a piezo crystal to sense angular changes. See Gyros and Governors.
Pitch-to-rudder mix: see
REVO
.
PITCH CURVE
: (
HELI
 FXUYH WKDW VHWV WKH UHVSRQVH RI WKH FROOHFWLYH SLWFK VHUYRV WR PRYHPHQW RI WKH WKURWWOHFROOHFWLYH
STICK,QGHSHQGHQWO\DGMXVWDEOHLQWKHQRUPDOÀLJKWPRGHRQHIRUHDFKRIWKHWKUHHLGOHXSVDQGRQHIRUWKURWWOHKROG
Adjusted to provide ideal blade response for various types of maneuvers being performed. For simplicity, the normal
condition's curve may be set in the
BASIC
PHQX$OO¿YHFXUYHVDUHDOVRDGMXVWDEOHLQWKH
ADVANCE
menu. ..................... 99
PPM: Pulse Position Modulation. Type of signal transmission.
Programmable mix: used to cause specific servo responses to specific inputs separate from the basic control setups.
,QFOXGHVH[WHQVLYHGH¿QLWLRQVRIW\SHVDQGH[DPSOHV ........................................................................................................ 68
5DQJHFKHFNRUWHVWWRWHVWWKHWUDQVPLWWHULVFRQWURORYHUWKHPRGHODWDVSHFL¿FGLVWDQFHDVDSUHFDXWLRQLQFKHFNLQJLWV
SURSHURSHUDWLRQSULRUWRÀLJKW............................................................................................................................................ 18
Rate: amount of control given. Ex: see Programmable mix.
RESET
: to delete all data in the existing model only. User CANNOT erase all data in the radio. Only service center can do
so. Part of
PARAMETER
submenu. ......................................................................................................................................... 33
5HWUDFWDEOHODQGLQJJHDUODQGLQJJHDUWKDWLVEURXJKWXSLQWRWKHPRGHOGXULQJÀLJKW ..................................................... 74
REVERSE
: servo reversing. Used to reverse the direction of a servo to ease installation and set up. .................................... 38
Rudder-to-aileron mix: (
ACRO

GLID
) used to counteract undesirable roll (roll coupling) that happens with rudder
input, especially in knife-edge. Gives proper aileron input to counteract roll coupling when rudder is applied. Not a
pre-programmed mix. See Programmable mix. This is the default programming for one linear and one curve mix in
ACRO
and
GLID
.
Rudder-to-elevator mix: used to counteract undesirable pitch (pitch coupling) with rudder input, especially in knife edge
ÀLJKW1RWDSUHSURJUDPPHGPL[6HHProgrammable mix
. This is the default programming for one curve mix in
ACRO
.
Rudder-to-throttle mix: (
HELI
) adds throttle to counter the added load from increasing pitch of the tail blades, maintaining
a constant head-speed with rudder. (This is a minor effect and is not critical in most helicopters.) Not a pre-programmed
mix. See Programmable mix.