FUTABA 10CAG - Page 70

70
GOAL of EXAMPLE: STEPS: INPUTS:
Set up a
FLAP-ELEV
mix:
ON
when SWITCH C is in the down
position.
1RHOHYDWRUPRYHPHQWZKHQÀDSVPRYH
up (spoilers),
5% elevator movement when flaps
move down,
LINK
should be
ON
if model has twin
elevator servos. Otherwise,
LINK
remains
OFF
.
(Flap has no trim lever, so
TRIM
is not
an option.)
Open an unused programmable mix.
(Ex: use
PROG.MIX3
since it is already
set-up for
FLAP-ELEVATOR
.)
for 1 second.
(If
BASIC
, again.)
C
to
PROG.MIX-
.
C
to
3 >
.
Activate the function.
C
to
MIX
. to
ON
.
Choose master and slave channels.
(Ex: no need to change
MASTER/SLAVE
.)
already
CH6
already
CH2
Optional: set Master as
OFST
or
VR(A-E)
.
See above for details.
C
to
MASTER
. to desired choice.
Set LINK and TRIM as needed.
(Ex: leave
LINK OFF
,
TRIM
not available.)
Assign SWITCH and position.
(Ex: change from
E
to
C
,
DOWN
.)
C
to
SW
. to
C
.
C
to
POSI
. to
DOWN
.
Optional: set switch to
STk-THR
to
activate mix with THROTTLE STICK.
(See above for details.)
C
to
SW
. to
STk-THR
.
C
to
POSI
.
THROTTLE STICK to desired
point.
for 1 second to set.
Optional: set switch position to
NULL
.
Makes mix active at all times. Not
compatible with
STk-THR
.
C
to
POSI
. to
NULL
.
Set rates. (Ex: Lo=
0%
, Hi=
5%
.)
C
to
RATE
.
VR(A) past center. Leave at
0%
.
VR(A) past center. to
5%
.
Set
OFFSET
, if needed. (Ex:
0
.)
C
to
OFFSET
. Leave at
0%
.
Close menu.
Where next? Adjust servo
END POINTs
: see p. 39.
6HWXSGXDOWULSOHUDWHVDQGH[SRQHQWLDO
D/R
,
EXP
): see p. 42.
Set up additional programmable mixes, ex:
RUDDER
-
AILERON
: see p. 68.
View numerous additional mix setups: www.futaba-rc.com\faq\
Other Examples:
•
RUD-ELEV
(
ACRO

GLID
) mix: Compensate for pitching up or down when rudder is applied.
•
AIL-RUD
mix (
ACRO
): Coordinate turns by applying rudder automatically with aileron input. All model types.
•
ELEV-PIT
(
HELI
) mix: compensate for the loss of lift of tilting the model.