FUTABA 10CAG User Manual

72
GOAL of EXAMPLE: STEPS: INPUTS:
Set up a
RUDD-ELEV
curve mix on a
model that pitches down severely at
full rudder and not at all with minimal
rudder input, and pitches worse on right
rudder than left:
Point 1: 25%
Point 2: 8%
Point 3: 0%
Point 4: 10%
Point 5: 28%
ON
when SWITCH C is down.
LINK
should be
ON
if model has twin
elevator servos. Otherwise,
LINK
remains
OFF
.
(Note that point 3 is 0%. Otherwise,the
elevator would be retrimmed when the
mix is active and no rudder input is
given.)
Open an unused curve programmable
mix. (Ex: use
PROG.MIX7
since it is
already set-up for
RUDDER-ELEV
.)
for 1 second.
(If
BASIC
, again.)
C
to
PROG.MIX-
.
C
to
7 >
.
Activate the function.
to page 2.
C
to
MIX
. to
ON
.
Choose master and slave channels.
(Ex: do not change
MAS
or
SLV
).
already
RUDD
already
ELEV
Set
LINK
as needed. (Ex: off)
Assign SWITCH and position.
(Ex: change from
F
to
C
,
DOWN
.)
C
to
SW
. to
C
.
C
to
POSI
. to
DOWN
.
Optional: set switch to
STk-THR
to
activate mix with THROTTLE STICK.
(See above for details.)
C
to
SW
. to
STk-THR
.
C
to
POSI
.
THROTTLE STICK to desired
point.
for 1 second to set.
Optional: set switch position to
NULL
.
Makes mix active at all times. Not
compatible with
STk-THR
.
C
to
POSI
. to
NULL
.
Set desired percent at the stick points.
(Ex: listed at left.)
to page 1.
C
to
POINT-1
. to
25%
.
Repeat for points 2-5.
Close menu.
Where next? Adjust servo
END POINTs
: see p. 39.
Set up
AILEVATOR
: see p. 57.
Set up linear programmable mixes, ex:
RUDDER-to-Aux2
(twin rudder servos):see p.
68, or additional curve mix, ex:
RUDDER-AILERON
: see p. 71.
View numerous mix setups: www.futaba-rc.com\faq\

FUTABA 10CAG Specifications

General

Brand	FUTABA
Model	10CAG
Category	Remote Control
Language	English