FUTABA 6EXAP - Flap Trim Function; Flap Trim Activation

15
15
3. Push the DATA INPUT lever upward. This will cause the flashing “INH
INH
” display to change to a
flashing
“ON
ON
” display. Now the mixing is on.
4. If needed to set ailerons differential. Press the SELECT key to display the flashing
“%” sign.
Use the DATA INPUT lever to set the percentage of ailerons differential from -100% to
+100% (The
“-” direction indicates decreasing amount of movement toward the upward from
the aileron surface, while
“+” direction indicates decreasing amount of movement toward the
downward from the aileron surface.)
5. Once this mix has been activated, move the servos to their full extremes to make certain they are not overdriving the
controls. If necessary, adjust the linkages to achieve the correct control throws.
FLTR Flap trim
FLTR Flap trim
The Flap Trim function is used to specify the amount of flap travel produced moving the flap control (the Flap control dial).
As normal flap control dial will be inhibited to use if the flaperon function is activated, the Flap Trim function should be
activated if you need to control flap by Flap control dial.
To activate flap trim:
To activate flap trim:
1. Enter the programming mode. Access the
“FLTR
FLTR
” screen with the MODE key.
2. If
“INH
INH
” is blinking, push DATA INPUT lever upward. Then you will see that the blinking
“INH
INH
” changes to “ON
ON
”. Your flap trim is now turned on.
3. Set the travel of the flap control dial at between -100% and +100% by using DATA INPUT
lever.