Need help?Do you have a question about the FUTABA 6EXP and is the answer not in the manual?
General| Channels | 6 |
|---|---|
| Frequency | 2.4 GHz |
| Modulation | FHSS |
| Type | Computer Radio System |
| Model Memory | 10 |
Diagram and brief explanations of the Futaba T6EXP transmitter controls.
Guidance on properly mounting the receiver antenna and protecting the receiver.
Details on storing and selecting up to six different model memories.
Monitoring battery voltage, mixer alerts, and backup error warnings.
Selecting active model memory and resetting data to factory defaults.
Choosing ACRO/HELI mode and PPM/PCM transmission.
Activating the trainer function for student-instructor flying.
Setting servo direction and dual rate throws for flight controls.
Assigning a recognizable name to each model memory for quick identification.
Fine-tuning servo response and travel limits.
Adjusting servo neutral positions for precise flight trimming.
Custom mixing of channels for advanced flight control adjustments.
Setting Flaperon and Flap Trim mixing for aircraft.
Configuring V-tail mixing for specific aircraft types.
Setting Elevon mixing for tailless or flying wing aircraft.
Setting 5-point throttle and pitch curves for normal and idle-up flight.
Enabling throttle hold for autorotations and engine idling.
Configuring Pitch-Rudder (REVO) and Gyro mixing.
Setting Swash-Throttle mixing and Swashplate types/AFR.
Configuring default servo positions during radio interference.
Using the trainer function and setting up the throttle-cut feature.
Adjusting control stick length and selecting transmitter stick modes.
Essential checks including controls, radio range, and frequency compliance.
To Next Page
