Need help?Do you have a question about the FUTABA T18MZ WC and is the answer not in the manual?
General| Type | Transmitter |
|---|---|
| Frequency | 2.4 GHz |
| Channels | 18 |
| SD Card Slot | Yes |
| Voice Alerts | Yes |
| Trainer System | Yes |
| Telemetry | Yes |
| System | FASSTest, FASST |
| Display | Color LCD |
| Operating System | Futaba Operating System |
| Gimbals | Hall Effect |
| Programming Features | Advanced programming features available |
| Model Memory | 30 models |
Important warnings regarding antenna handling to prevent damage and ensure proper operation.
Procedure for locking the touch panel to prevent accidental activation during flight.
Step-by-step guide for removing and installing the transmitter battery.
How to properly connect a battery to the receiver for power.
Guidelines for optimal placement of receiver antennas for best signal reception.
Safety guidelines for installing servos, lead wires, power switches, and the receiver.
How to connect and utilize telemetry sensors for data monitoring.
Procedures for charging the transmitter and receiver batteries.
Correct procedures for turning the transmitter on and off to prevent data loss.
Steps for adding models, selecting types, and basic linkage for airplanes/gliders.
Steps for adding models, selecting types, and flight conditions for helicopters.
Settings for throttle cut, idle down, swash mixing, and throttle mixing for optimal performance.
Displaying telemetry data, setting warnings, and managing data logging.
Step-by-step guide for updating the transmitter firmware via SD card.
To Next Page
