FUTABA T18MZ WC User Manual

120
＜
Model Menu (Common Functions)
＞
ŏ5HWXUQWR0RGHO0HQX
ŏ7RXFKWKH>3URJ0L[HV@EXWWRQLQWKH0RGHO0HQXWR
call the setup screen shown below.
3URJ0L[HV
3URJUDPPL[LQJZKLFKFDQEHIUHHO\FXVWRPL]HG8SWRPL[LQJVFDQ
EHXVHGIRUHDFKFRQGLWLRQ>$OOPRGHOW\SHV@
Programmable mixing may be used to correct
undesired tendencies of the aircraft, and it may also
be used for unusual control configurations. Mixing
means that the motion of a command channel, called
the "master," is added to the motion of the mixed
channel, called "slave."
You may choose to have the Masters trim added to
the Slave channel response, if you desire ("Trim"
setting). The mixing curve can be changed so that
the undesired tendencies can be corrected effectively
by setting the LINEAR1/LINEAR2/EXP1/EXP2/
VTR/LINE/SPLINE modes. The Delay function can
be programmed for each rate. The Delay is used to
change the rate smoothly when switching. You may
de¿ne Mixing ON/OFF switch, control or you may
choose to have mixing on all the time.
Offset-type mixing applies a ¿xed offset or preset to
the programmed channel servo operation and may
control up to four circuits simultaneously.
The Programmable mixing includes a powerful link
function, which allows Programmable mixing to be
linked with the special mixing functions, or with
other programmable mixing functions. The link
function can be set up for Master and Slave channel
individually.
The slave channel AFR mode (STK-STK mode) may
be selected, where the slave channel AFR and D/R
settings are observed when Link function is set. The
knob for ¿ne tuning can be set up for every mixing
circuit. (Fine tune function)
0L[LQJEXWWRQV
After this function is activated, the
master and slave function names (or
offset mixing) are displayed.
ŏ0L[LQJPRGHFKDQJHEXWWRQ
ŏ*URXSVLQJOHPRGHVZLWFKLQJ*U6QJO
)RUPRUHLQIRUPDWLRQVHHWKHGHVFULSWLRQDWWKHEDFNRI
this manual.)
ŏ2SHUDWLRQFXUYHVHWWLQJ
ŏ6HUYRVSHHGVHWWLQJ
ŏ6ZLWFKVHOHFWLRQ
ŏ)LQHWXQLQJWULPVHWWLQJ
(Timer mode)
1RUPDOPRGH
7LPHUPRGH
The on time (start/stop time) can be set up to 35
seconds. It is useful for landing gear control of
the jet or scale plane, etc.
(Offset-type mixing) (Curve-type
mixing)
+(/,&237(5
$,53/$1(
*/,'(5

FUTABA T18MZ WC Specifications

General

Brand	FUTABA
Model	T18MZ WC
Category	Remote Control
Language	English