FUTABA T18MZ WC - At the Flying Field

9
＜
Introduction
＞
$WWKHs\LQJrHOG
To prevent possible damage to your radio gear turn the poZer sZitches on and off in the proper
seTuence:
1. Pull throttle stick to idle position or otherZise disarm your motor/engine.
2. Turn on the transmitter poZer and alloZ your transmitter to reach its home screen.
3. Con¿rm that the proper model memory has been selected.
4. Turn on your receiver poZer.
5. Test all controls. If a servo operates abnormally don’t attempt to Ày until you determine the
cause of the problem.
Test to ensure that the Fail Safe settings are correct after adjusting them. Turn the transmitter off
and con¿rm the proper surface/throttle movements. Turn the transmitter back on.
. Start your engine.
7. Complete a full range check.
8. After flying bring your throttle stick to idle position engage any kill sZitches or otherZise
disarm your motor/engine.
9. Turn off receiver poZer.
10. Turn off transmitter poZer.
If you do not turn on your system in this order you may damage your servos or control surfaces
Àood your engine or in the case of electric-poZered or gasoline-poZered models the engine may
unexpectedly turn on and cause a severe injury.
While you are getting ready to fly if you place your transmitter on the ground be sure that
the Zind Zont tip it over. If it is knocked over the throttle stick may be accidentally moved
causing the engine to speed up. Also damage to your transmitter may occur.
In order to maintain complete control of your aircraft it is important that it remains visible at all
times. Flying behind large objects such as buildings grain bins etc. is not suggested. Doing so
may result in the reduction of the Tuality of the radio freTuency link to the model.
Do not grasp the transmitters antenna during Àight. Doing so may degrade the Tuality of the
radio freTuency transmission.
As Zith all radio freTuency transmissions the strongest area of signal transmission is from
the sides of the transmitters antenna. As such the antenna should not be pointed directly at
the model. If your Àying style creates this situation easily move the antenna to correct this
situation.