FUTABA T18MZ WC - Model Menu (Helicopter)

152
＜
Model Menu (Helicopter Functions)
＞
02'(/0(18+(/,&237(5
This section contains information on the commands
that apply to helicopters only. For instructions on
Airplanes and Gliders, refer to the sections pertaining
to those aircraft. Each of these functions can be set
independently for different Àight conditions. To get
to these settings, touch the desired function button to
be accessed.
Use the Model Type function in the Linkage Menu
to select the swash type matched to the fuselage
beforehand. If you later change model types, all
settings will be lost.
Also, add flight conditions at the Condition Select
screen before setting the model data at each function.
(Up to 8 conditions can be used)
The AFR function, fuel mixture and other functions
common to all model types, are described in a
separate section.
ŏ5HWXUQWR+RPHVFUHHQ
ŏ7RXFKWKH0RGHO0HQXEXWWRQRIWKH+RPHVFUHHQWR
FDOOWKHPHQXVKRZQEHORZ7RXFKWKHEXWWRQRIWKH
IXQFWLRQ\RXZDQWWRVHWWRFDOOWKHVHWXSVFUHHQ
0RGHO0HQXIXQFWLRQVKHOLFRSWHUWDEOH
Condition Hold function ON/OFF button
)RUDGHWDLOHGGHVFULSWLRQVHH3&RQGLWLRQ+ROGIXQFWLRQ
PIT Curve: Adjusts response in different Àight conditions
THR Curve: Throttle curve and hovering trim adjustment
Acceleration: Counteracts torque due to sudden throttle and pitch commands
Throttle Hold: Moves the throttle to idle during autorotation
Swash Mix: Compensates for each control response
Throttle Mix: Compensates for power loss when cyclic applied
Pit to Needle: Adjusts response curve in different Àight conditions
Pit to RUD: Handles torque changes from pitch angle inputs
Fuel Mixture: Commands a second servo to adjust the fuel mixture at the carburetor
Gyro: Used to switch Futaba GY series gyro sensitivity
Governor: Used to switch RPM of the helicopter’s head
Throttle Limiter: Limits the high range of the throttle movement by any slider or trimmer
+(/,&237(5