FUTABA T18MZ WC - Servo; Toolbox; Stylus Pen

28
＜
Before Use
＞
Toolbox
ٴ7RROIRUUHPRYLQJ
GHFRUDWLRQQXWV
ٴ+H[:UHQFKPPDQGPP
ٴ5XEEHU&DS
A special toolbox is included with your T18MZ-
WC. This allows you to make all of the mechanical
adjustments that may be needed.
Hexagonal wrench (1.5mm and 2.5mm)
These wrenches are for adjustment of sticks and
replacement of the switches.
Tool for removing switch nuts.
This is used when changing or replacing switches.
Stylus pen
A rubber cap is attached to the stylus pen/toolbox.
You may use this stylus with rubber cap when
operating the touch panel. The stylus allows more
precise operation than fingers without fear of
damaging the panels surface.
ٴ<RXPD\XVHWKLVWRRO
DVDVW\OXVSHQ
6HUYR2SWLRQ
・
7RROER[
Servo (Option)
Purchase servos appropriate for their intended use.
*Analog servos may not be used when operating in the
FASSTest 12CH mode.
When operating in the FASSTest12CH mode use digital
servos, this includes all brushless and S.Bus servos.