FUTABA T18MZ WC - Throttle Hover Trim

157
＜
Model Menu (Helicopter Functions)
＞
Normal Curve Idle-up 1 Curve Idle-up 2 Curve
Ɣ7KroWWle Curve ([ample
The curves shown below were created by using the
Line mode and inputting the data of the 5 points
0% (low side), 25%, 50% (center), 75%, 100%
(high) side at each condition. They were created by
reducing the number points of the line to 5. When
actually creating a curve, enter the data speci¿ed per
the fuselage (or the reference value).
Curve setting examples
ŏ5HWXUQWR0RGHO0HQX
7KURWWOH+RYHUWULP
The Throttle Hover trim setup screen can be called from the THR Curve setup screen.
ŏ6HWV7KURWWOH+RYHUWULP
ŏ6HWVWKHGLDOXVHG
The Throttle Hover function trims the throttle near
the hovering point. Normally, use it with hovering
conditions. Changes in rotor speed accompanying
changes in the temperature, humidity, and other Àight
conditions can be trimmed. Adjust the throttle so that
rotor rotation is most stable. More delicate trimming
is also possible by using this function along with the
Hover Pitch function.
Setting method
ŏ:KHQXVLQJWKHKRYHULQJQRUPDOFRQGLWLRQRQO\
VZLWFKWKH>*U@JURXSEXWWRQPRGHWRWKH>6QJO@
VLQJOHPRGHDQGPDNHWKHVHWWLQJV
ŏ6HWWKHIXQFWLRQWR$&7>21@
ŏ6HOHFWWKHDGMXVWPHQWNQRE6HOHFWLRQH[DPSOH5'
ŏ7KHWULPRSHUDWLRQPRGH0RGH&7501250FDQ
EHVHOHFWHG
 CTRM mode:0D[LPXPFKDQJHQHDUFHQWHUE\
FHQWHUWULPRSHUDWLRQ'RHVQRWFKDQJHDWHQGRI
WKHVWLFNPRYHPHQW
 NORM mode: 1RUPDOWULPOLQHDURSHUDWLRQ7KH
DGYDQWDJHRIXVLQJWKLVPRGHLVWKDWKRYHULQJ
WKURWWOHFDQEHDGMXVWHGZLWKRXWFKDQJLQJWKH
FXUYH
ŏ7ULPDGMXVWPHQWUDQJH5DQJHVHWWLQJ
 :KHQWKHYDOXHLVPDGHVPDOOWULPDFWVRQO\QHDU
WKHFHQWHU
ŏ7KHWULPUDWHFDQEHDGMXVWHGDQGWKHRSHUDWLRQ
GLUHFWLRQFDQEHVHW
+(/,&237(5