FUTABA T18MZ WC - S.BUS and S.BUS2 SYSTEMS

31
＜
Before Use
＞
6%86,QVWDOODWLRQ
This set uses the S.BUS system. The wiring is as simpli¿ed and clean mounting as possible, even with models
that use a large number of servos. In addition, the wings can be quickly installed to the fuselage without any
erroneous wiring by the use of only one simple wire, even when there are a large number of servos used.
ƔWhen using S.BUS, special settings and mixes in your transmitter may be unnecessary.
ƔThe S.BUS servos and S.BUS gyros memorize the number of channels themselves. (Settable with the T18MZ-
WC)
ƔThe S.BUS system and conventional system (receiver conventional CH used) can be mixed.
Receiver:R7008SB
Battery:FR2F1800(Optional)
Switch:ESW-1J
Throttleservo:BLS173SV(Optional)
Aileronservo:BLS174SV×2(Optional)
Elevatorservo:BLS173SV×2(Optional)
RudderServo:BLS175SV×1(Optional)
HUB×3(Optional)
HUB(Optional)

S.BUS Gliderusageexample
S.BUSAerobaticplaneusageexample

Receiver:R7008SB
Servo:S3173SVi×9(Optional)
i-Connector(Optional)