86
<
Linkage Menu
>
+(/,&237(5
$,53/$1(
*/,'(5
ŏ5HWXUQWR/LQNDJH0HQX
ŏ7RXFKWKH>(QG3RLQW$79@EXWWRQLQWKH/LQNDJH
0HQXWRFDOOWKHVHWXSVFUHHQVKRZQEHORZ
(QG3RLQW$79
6HWVWKHWUDYHOOLPLWSRLQWDQGVSHHGRIHDFKVHUYR
7KHGLVSOD\VFUHHQLVDQH[DPSOH7KHVFUHHQGHSHQGVRQWKHPRGHOW\SH
The End Point function adjusts the left and right
servo throws, generates differential throws, and will
correct improper linkage settings.
The travel rate
(normal full stick movement at high
rates) can be varied from 30 to 140 in each
direction on channels 1 to 16. Also, the limit point
(how far the servo travels when a mix is involved)
where servo throw stops may be varied from 0 to
155.
Servo travel adjustment
7RXFKWKHWUDYHOEXWWRQRIWKHFKDQQHO\RX
ZDQWWRVHW$GMXVWPHQWEXWWRQVDSSHDURQ
WKHVFUHHQ
8VHWKHVHEXWWRQVWRDGMXVWWKHUDWH
ŏ,QLWLDOYDOXH
ŏ$GMXVWPHQWUDQJHa
5HSHDWWKHSURFHGXUHDERYHIRUHDFKUDWH
Limit point adjustment
7RXFKWKHOLPLWEXWWRQRIWKHFKDQQHO\RX
ZDQWWRVHW
8VHWKHDGMXVWPHQWEXWWRQVWRDGMXVWWKHOLPLW
SRLQW
ŏ,QLWLDOYDOXH
ŏ$GMXVWPHQWUDQJHa
5HSHDWWKLVSURFHGXUHIRUHDFKOLPLWSRLQW
Note:
The indicators on the screen display actual servo throw
of the each channel. The center position of the indicator is
based on the Sub-Trim settings. Therefore the Sub-Trim
adjustment changes the Limit point display of the indicator.
The Servo Speed setting is used to set the servo delay for
each channel, from channel l to channel 16. The system uses
the programmed speed (delay) to slow down servo position
changes. The Servo Speed setting can be varied from 0 to 27
in each channel.
Servo speed setting
7RXFKWKH6SHHGEXWWRQRIWKHFKDQQHO\RX
ZDQWWRVHW
8VHWKHDGMXVWPHQWEXWWRQVWRDGMXVWWKHVHUYR
VSHHG
ŏ,QLWLDOYDOXH
ŏ$GMXVWPHQWUDQJHaVWHSV
5HSHDWWKLVSURFHGXUHIRUHDFKFKDQQHO
7RFORVHWKLVVFUHHQWRXFKWKH>(QG3RLQW$79@
EXWWRQ
30 〜
140%
30 〜
140%