FUTABA T18MZ WC - Home Screen

38
＜
Basic Operation
＞
①
Timer
If one of two timer displays is pushed, you will
enter the Timer screen of a Linkage menu.
In the button mode of a timer set, it can
also be made a start/stop.
A push on reset will reset a time.
②
Menu Button
•

System menu • Linkage menu
⑬
Menu Button
•

Model menu
⑦
Home2
A timer and Telemetry data change to
Home2 screen by which it was indicated
by expansion.
WARNING
Be sure to con¿rm the model name before
Àying your aircraft.
Check the remaining battery as often as
possible and try to charge the battery
regularly. If the battery alarm sounds and
its warning symbol is displayed, land your
aircraft immediately.
+RPHVFUHHQ
⑪
Condition
The condition name that is currently used
is displayed here.
• Push this area to enter the Condition
Select screen.
⑮
Clock
This shows the today's date and the
current time.
• Push this area for the Date & Time Setting
screen.
⑩
User's name
Push this area to enter the User's Name
Setting screen.
③
System Selection
• FASSTest18CH • FASSTest12CH • FASST
MULTI • FASST 7CH • S-FHSS • T-FHSS
④
System timer/Reset
• This shows the total accumulated time
used for the transmitter. This can be reset.
(Hour):(Minute):(Second)
Push this area to reset the timer.
⑥
Direct buttons
Select and press one of the direct buttons
to enter the menu.
This is the Home screen and descriptions of it's menus. Use your ¿nger or included stylus pen to
operate the touch screen.
⑫
Battery Indicator
•When the remaining battery reaches 30%,
the alarm will beep. Land your aircraft
immediately.
⑧
RF Indicator
"ON AIR" or "RF OFF"
⑨
Digital trim (T1 to T6, CD)
Push this area to enter the Dial Monitor
screen.
⑭
Model Name
The model name that is currently used is
displayed here.
• Push this area to enter the Model Select
screen.
⑤
Voltage of Rx/Ext battery
Information from the receiver is displayed
when using a bidirectional system.
FASSTest/T-FHSS Only.
⑬
⑭
⑮
①
②
③
④
⑤
⑥
⑦⑧⑨⑩⑪⑫