FUTABA T18MZ WC - Switch Selection Method; Switch Mode Selection (Single SwitchLogic Switch); If Using the Single Switch; If Using the Logic Switch

173
＜
Data
＞
6ZLWFKVHOHFWLRQPHWKRG
The various functions used in the T18MZ-WC can be selected by switch. The switch (including when stick, trim
lever, or VR are used as a switch) setting method is common to all functions.
Switch mode selection (Single switch/Logic switch)
When the switch select button in a mixing function screen or other screen is touched, the switch mode selection
screen shown below is called. Single mode or logic mode can be selected.
(Switch mode selection screen example)
Logic switch
The Logic switch can activate functions by the use of other switch
combinations. Up to 4 switch combinations can be set. The Logic switch can
be assigned to the mixing function as well as the Àight condition select (except
for Snap roll function on airplane mode).
ŏ0RGHVHOHFWLRQEXWWRQ
ŏ6ZLWFKVHOHFWLRQEXWWRQ
,QFDVHRIWKHÁLJKWFRQGLWLRQVHOHFWWKH
top of the switch on/off status display is
not shown.
If using the single switch:
3XVKWKHVZLWFKVHOHFWLRQEXWWRQ
*The switch selection screen appears.
If using the logic switch:
1.The switch mode display is changed by
pushing the mode selection button. Then
SXVKWKH><HV@EXWWRQ
*The logic mode setting screen appears.
)RUDGHVFULSWLRQRIWKHORJLFPRGHVHWWLQJ
method, see the section "Logic switch" below.