Need help?Do you have a question about the FUTABA T12K and is the answer not in the manual?
General| Type | Transmitter |
|---|---|
| Channels | 12 |
| Frequency | 2.4 GHz |
| Telemetry | Yes |
| Display | LCD |
| Model Memory | 30 |
Information on obtaining support, service procedures, and compliance statements.
Guidelines regarding the product's use, export, and unauthorized modifications.
Essential safety warnings and precautions for using the transmitter and associated equipment.
Overview of the T12K's capabilities and detailed technical specifications.
Details on compatible communication systems and usable receivers.
List of optional accessories recommended for use with the T12K system.
Identification and explanation of all buttons, switches, and controls on the transmitter.
Step-by-step guide for installing, removing, and charging the transmitter battery.
Explanation of the transmitter antenna's positioning and function, and switch types.
Explanation of stick operation, adjustments for length and tension.
How to use digital trims for fine adjustments and the push dial for menu navigation.
Explanation of navigation buttons and analog input controls like volume and slide levers.
Information on external connectors and micro SD card usage and precautions.
Identification of receiver parts and guidance on antenna installation and channel modes.
Details on S.BUS/S.BUS2 installation, wiring, and telemetry system setup.
Procedures for turning the transmitter on/off and registering a user name.
Understanding the home screen and customizing the user menu for quick access.
Step-by-step guide for linking the transmitter with receivers for T-FHSS Air and S-FHSS systems.
Procedure for performing a range check to ensure reliable radio communication.
How to connect servos based on the selected model type for optimal channel assignment.
Steps for adding and configuring new models, including type and system selection.
How to set up and use the trainer function for instructing pilots.
Adjusting LCD, sound options, and hardware settings like reverse and stick modes.
Setting up quick model selection, auto lock, and accessing system information.
Detailed explanation of S.BUS servo functions and parameter settings.
Introduction to the Linkage Menu and a table of its functions.
Using the servo monitor and managing model data (select, add, copy, delete).
Selecting model types and configuring system settings like mode and receiver link.
Assigning functions to channels and fine-tuning servo parameters (trim, reverse, endpoint).
Configuring fail safe settings and throttle cut/idle down functions.
Adjusting mixes for control surfaces and configuring gyro sensitivity.
Adjusting trim offsets and flap/aileron functions for flight conditions.
Configuring gyro sensitivity, modes, and types for flight stabilization.
Setting up tail control mixes for specific aircraft configurations.
Adjusting motor speed and mixing rudder with elevator.
Configuring switch and rate adjustments for snap roll maneuvers.
Setting up flight modes for multicopter control via switches.
Introduction to helicopter-specific functions and model setup.
Setting pitch curves and trims for different flight conditions.
Adjusting throttle curves and hover trim for optimized helicopter performance.
Configuring throttle limits, hold, and swash plate mixing for helicopters.
Configuring gyro sensitivity, modes, and types for helicopter flight stabilization.
Configuring and operating the two independent timers for various measurements.
Detailed guide on assigning functions to switches and setting logic modes.
To Next Page
