Data input operation is performed using the Push dial.
Movement of cursor, value input or mode
selection:
Movement of the cursor on the menu screen
and movement of the cursor among items on a
setup screen can be controlled by scrolling your
nger to the left and right in the direction of the
arrow in the scrolling diagram above. You can
also go to the next page, if there is a next page.
This scrolling technique is also used for data
input, value input, mode selection, and similar
operations. Examples include: Value, ON, OFF,
INH, ACT, etc.
Push Dial
Push Dial：
Dial Scroll
The cursor moves accordingly.
Increases or decreases values accordingly.
Right part Long Push
[SYS]
Jump to System Menu screen directly.
Upper part Long Push
[LNK]
Jump to Linkage Menu screen directly.
Left part Long Push
[MDL]
Jump to Model Menu screen directly.
Lower part Long Push
[S1]
To Home screen
Lower part Push
[S1]
The cursor moves to the top of next page.
The cursor moves to the top of page.
Center part Long Push
[RTN]
Reset to the initialized value.
Center part Push
[RTN]
Change to the input data mode.
Changes to the moving cursor mode.
The data is entered.
Push the
outer dial
part
Long Push：1 second or more
Push：Less than 1 second
Upper part
Push
Center part
Push
Lower part
Push
Right part
Push
Left part
Push
RTN button:
Push the RTN button when you want to open
a setup screen or to switch between cursor move
mode (reverse display) and data input mode (box
display).
This button can also be used as the enter button
when a conrmation message is displayed on the
screen, etc.
Push Dial Operation
To Next Page
Loading...
