FUTABA T12K

163
<Model Menu (Airplane/Glider/Multirotor Functions)>
●Selectthefunctionname
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
<Push Dial>
RETURN
RUDDER 1
Winglet
at Flying wing
( )
RUDDER 2
Winglet
at Flying wing
( )
WINGLET
[Correspondingmodeltype]:Airplane/glider,Flyingwingonly
This function adjusts the left and right rudder
angles of airplanes with winglets.
Winglets are used to improve the efficiency of
aircraft by lowering the lift-induced drag caused by
wingtip vortices. The winglet is a vertical or angled
extension located at the tip of each wing.
Winglets work by increasing the wing's effective
aspect ratio without adding to the structural
stress and weight of its structure. An extension of
wingspan would also permit lowering of induced
drag, though it requires boosting the wing's
strength and weight. A winglet helps solve this
by effectively increasing the aspect ratio without
adding to the wingspan.
(Rudder1/2)
●Thetravelduringrudderstickoperation
can be individually adjusted.
●Select[WINGLET]attheModelmenu
and access the setup screen shown
below by pushing the RTN button.
Setting method
● Travel adjustment
Move the cursor to the item you want to
adjust and push the RTN button to switch to
the data input mode.
 AdjusttheratebyscrollingthePushdial.
 Initialvalue:+100%
 Adjustmentrange:-120~+120%
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
 PushtheRTNbuttontoreturntothecursor
mode.
*If the mixing direction is reversed, change the mixing rate
polarity (+ or -).
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Toinputdatamode
●Dataisentered