Warning
Be careful not to drop the battery.
Never disconnect the battery before the
T12K has completely shut down and the
transmitter screen is blank.
* Internal devices such as memories may be damaged.
* If any problems occur, the message “Backup Error”
will appear when you turn on the transmitter. If this
happens, do not use the transmitter. Send it to the
Futaba Service Center.
Installation and Removal of the Transmitter Battery
NiMH Battery HT5F1800B
Slide the battery cover
off the transmitter in the
direction of the arrow in the
gure.
Push
Insert the connector of the
battery and load the battery
into the transmitter.
Connect the battery
connector.
Finish by installing the
battery cover.
Danger
When closing the battery cover, be
careful that the battery cover does
not pinch the battery lead wires.
Battery lead wire shorts could lead to
abnormal heating, re, and/or could cause
burns or large scale res.
Turn o the transmitter
power switch.
To Next Page
Loading...
