FUTABA T12K

150
<Model Menu (Airplane/Glider/Multirotor Functions)>
●Selectthefunctionname
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
<Push Dial>
RETURN
ELE to CAMBER
[Correspondingmodeltype]:Airplane/glider,2aileronsormore
This function is used when you want to mix the
camber aps with elevator operation. When used,
the flaps are lowered by up elevator, and lift is
increased.
●In-ightmixingcanbeturnedON/OFFbyassigning
thistoaswitch.(AlwaysONat[--]setting)
●Themixingratecanbeadjusted.
●Thepointthathaslittleeffectneartheneutral
position of the elevator stick can be adjusted.
(Glideronly)
Note: The elevator on the tailless wing will also
be affected when this mix is activated.
●Mixing rate adjustment
Move the cursor to the up or down mixing
rate item for each servo and push the RTN
button to switch to the data input mode.
Adjusttherateindependentlybyscrolling
thePushdial.
 Initialvalue:0%
 Adjustmentrange:-100~+100%
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
 PushtheRTNbuttontoendtheadjustment
and return to the cursor mode.
Setting method
●Activate the function
 Movethecursortothe[ACT]itemandpush
the RTN button to switch to the data input
mode.SelecttheACTmodebyscrollingthe
Pushdial.
*The display blinks.
 PushtheRTNbuttontoactivatethefunction
andreturntothecursormode.(ONis
displayed.)
When setting a switch, move the cursor to
the[SW]itemandpushtheRTNbuttontocall
theselectionscreen.Selecttheswitchand
setitsONdirection.(AlwaysONat"--"setting)
*For a description of the switch selection method, see the
description at the back of this manual.
●Range setting (Glider only)
 Movethecursortothe[RANGE]itemand
hold the elevator stick to the desired position
(upperorlowerside)andthenpushtheRTN
button for one second to set the range.
*The mixing does not work near neutral of the elevator stick.
 Initialvalue:0%
 Adjustmentrange:0~100%
(Glider: Currently selected condition name)
●Select[ELEtoCAMBER]attheModelmenu
and access the setup screen shown below
by pushing the RTN button.
*The display screen is an example.
The actual screen depends on the
model type.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage
●Toinputdatamode
●Dataisentered