FUTABA T12K

100
<Functions of Linkage Menu>
●Selectthefunctionname
andreturntotheLinkage
menubypushingthe RTN
buttonor pushingthe
HOME/EXITbutton.
<Push Dial>
RETURN
TELEMETRY
Displayingdatafromthereceiver
This screen displays your choice of data from the
receiver.
Also warnings can be activated regarding
other data from your aircraft. For example, if the
receiver voltage drops, the user can be warned by
an alarm (and vibration).
*It cannot be used in S-FHSS mode
●Select[TELEMETRY]intheLinkagemenuand
accessthesetupscreenshownbelowbypushing
theRTNbutton.
●PushS1buttontoadvancetonextpage.
●[TELEMETRY]canbecallediftheHOME/EXITbutton
ispushedfromahome screen.
●Receiver->Transmitter.The
receptionstrengthisshown.
How to see telemetry data
1.TelemetryscreencanbecallediftheHOME/
EXITbuttonispushedfromthehomescreen.
Orselect[TELEMETRY]intheLinkagemenu
andaccessthesetupscreenbypushingthe
RTNbutton.
2.IfeachitemischosenandtheRTNbuttonis
pushed,analarmsetupcanbeperformed
withtheminimum/maximumaftera
transmitteristurnedon.
*Receiver voltage can be checked immediately. An optional
sensor will need to be attached to S.BUS2 of a receiver if
you would like to see other information.

*No special setup is necessary if each sensor displayed
is left as in the default setup. Separate sensor ID
is also unnecessary. However, if two or more of
one kind of sensor is used, setup is required in the
"SENSOR" menu.
Warning
Do not watch the transmitter screen during
ight.
*You may lose sight of the aircraft during ight and this is
extremely dangerous. Have an assistant on hand to check
the screen for you. A pilot should NEVER take his eyes
off his aircraft.
Scrolling
●Movingcursor
●Selectingmode
●Tonextpage
●Toinputdatamode
●Dataisentered