FUTABA T12K

146
<Model Menu (Airplane/Glider/Multirotor Functions)>
●Selectthefunctionname
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
<Push Dial>
RETURN
RUDDER 2
RUDDER
RUDDER
V-TAIL
RUDDER 2
Winglet
RUDDER 1
Winglet
at Flying wing
at Flying wing
( ) ( )
AIL 3
AIL 3
(Chip Aileron)
(Chip Aileron)
AIL1
(Main Aileron)
AIL 2
(Main Aileron)
RUD to AIL
[Correspondingmodeltype]:Airplane/glider,general
This function is used when you want to mix
the ailerons with rudder input. It is used when
rudder is applied during roll maneuvers, such
as knife edge flight. It can be used to turn or
bank scale models, large models, etc. like a full-
size aircraft.
●MixingduringflightcanbeturnedON/OFFby
settingaswitch.(AlwaysONat[--]setting)
●Linkingcanbeset:Linkthismixtoothermixes.
●Themixingratecanalsobeadjusted.
●Afive-pointcurvecanbesetatairplanemodel
type.
●Select[RUDtoAIL]attheModel
menu and access the setup screen
shown below by pushing the RTN
button.
*The display screen is an example.
The actual screen depends on the
model type.
Setting method
●Activate the function
 Movethecursortothe[ACT]itemandpush
the RTN button to switch to the data input
mode.SelecttheACTmodebyscrollingthe
Pushdial.
*The display blinks.
 PushtheRTNbuttontoactivatethefunction
andreturntothecursormode.(ONis
displayed.)
When setting a switch, move the cursor to
the[SW]itemandpushtheRTNbuttontocall
theselectionscreen.Selecttheswitchand
setitsONdirection.(AlwaysONat"--"setting)
*For a description of the switch selection method, see the
description at the back of this manual.
●Mixing rate adjustment (glider)
Move the cursor to the left or right item
and push the RTN button to switch to the
datainputmode.Adjustthemixingrate
independentlybyscrollingthePushdial.
 Initialvalue:0%
 Adjustmentrange:-100~+100%
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
 PushtheRTNbuttontoendtheadjustment
and return to the cursor mode.
●Link mode setting
To activate the link mixing, move the cursor
tothe[LINK]itemandpushtheRTNbutton
toswitchtothedatainputmode.Selectthe
ONmodebyscrollingthePushdial.
*The display blinks.
 PushtheRTNbuttontosetthelinkmodeand
return to the cursor mode.
(Glider: Currently selected condition name)
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Toinputdatamode
●Dataisentered