FUTABA T12K

106
<Functions of Linkage Menu>
●Selectthefunctionname
andreturntotheLinkage
menubypushingthe RTN
buttonor pushingthe
HOME/EXITbutton.
<Push Dial>
RETURN
TELEMETRY : TEMP.
Displayingdatafromthetemperature
TEMP is a screen which displays/sets up
the temperature information from an optional
temperature sensor.
The temperature of the model (engine, motor,
battery etc.) which is ying can be displayed.
If it becomes higher or lower than the setting an
alarm and/or vibration will alert you.
*It cannot be used in S-FHSS mode
●Select[TEMP.]intheTELEMETRYscreenandaccess
thesetupscreenshownbelowbypushingtheRTN
button.
●Pushthe S1buttontoadvancetothenextpage.
●Temperature
●Themaximumandtheminimumwhen
poweringONareshown.
●↓Adownwardarrow
willshowthatan
alarmwillsoundwhen
thetemperature
dropsbelowtheset
value.
●↑Anupwardarrowwill
showthatanalarm
willsoundwhenthe
temperaturerises
abovethesetvalue.
Alert set : Hot warning
1.Movethecursortothe↑ALERTitemandpush
theRTNbuttontoswitchtothedatainput
mode.
2.SelecttheACTmodebyscrollingthePush
dial.
3.PushtheRTNbutton.(Toterminatetheinput
andreturntotheoriginalstate,pushtheS1
button.)
4.Movethecursortothe↑THRESHOLD[+100
℃
]
itemandpushtheRTNbuttontoswitchto
thedatainputmode.
5.AdjusttheratebyscrollingthePushdial.
 Initialvalue:+100
℃
 Adjustmentrange:-19
℃
~200
℃
(↑THRESHOLD>↓THRESHOLD)
*When the RTN button is pushed for one second, the rate is
reset to the initial value.
6.PushtheRTNbutton.(Toterminatetheinput
andreturntotheoriginalstate,pushtheS1
button.)
Alert set : Low-temperature warning
1.2/2pageisaccessedbypushingS1.Move
thecursortothe↓ALERTitemandpushthe
RTNbuttontoswitchtothedatainputmode.
2.SelecttheACTmodebyscrollingthePush
dial.
3.PushtheRTNbutton.(Toterminatetheinput
andreturntotheoriginalstate,pushtheS1
button.)
4.Movethecursortothe↓THRESHOLD[+0
℃
]
itemandpushtheRTNbuttontoswitchto
thedatainputmode.
5.AdjusttheratebyscrollingthePushdial.
 Initialvalue:+0
℃
 Adjustmentrange:-20
℃
~199
℃
(↑THRESHOLD>↓THRESHOLD)
*When the RTN button is pushed for one second, the rate is
reset to the initial value.
6.PushtheRTNbutton.(Toterminatetheinput
andreturntotheoriginalstate,pushtheS1
button.)
TYPE 1
TYPE 2
TYPE 3
TYPE 4
"Vibes" type
Ifthefollowingtypesareselected,the
transmitterwillvibrateduringthewarning.
*A temperature sensor must be installed in the aircraft.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage
●Toinputdatamode
●Dataisentered