FUTABA T12K

87
<Functions of Linkage Menu>
●Selectthefunctionname
andreturntotheLinkage
menubypushingthe RTN
buttonor pushingthe
HOME/EXITbutton.
<Push Dial>
RETURN
SERVO SPEED
Setsthespeedofeachservo.
The speed of the servo from 1CH to 12CH
operation can be set up.
It can adjust from 0 to 27.
The initial speed value is "0". Servo speed will
slow as this value is increased to represent the
highest servo speed.
* Speed cannot be faster than the maximum rate of the servo
to be used.
Servo speed setting
1.PushtheSpeedbuttonofthechannelyou
wanttoset.
2.Usetheadjustmentbuttonstoadjustthe
servospeed.
●Initialvalue:0
●Adjustmentrange:0~27(steps)
*When the RTN button is pushed for one second, the rate is
reset to the initial value.
3.Repeatthisprocedureforeachchannel.
* You cannot use this method to change servo speed at the
same time you use the speed control of an S.BUS servo
setup. This will cause some overlap. Please only use one
method or the other.
* The speed of THR is not set up simultaneously with THR
DELAY (model menu : only airplane).
●Select[SERVOSPEED]intheLinkagemenuand
accessthesetupscreenshownbelowbypushing
theRTNbutton.
(The display screen is an example. The
screen depends on the model type.)
(channel)
(speed)
(speed)
(channel)
Scrolling
●Movingcursor
●Adjustingvalue
●Tonextpage
●Toinputdatamode
●Dataisentered