FUTABA T12K

137
<Model Menu (Airplane/Glider/Multirotor Functions)>
●Selectthefunctionname
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
<Push Dial>
RETURN
This function adjusts the pitch curve for VPP
(Variable Pitch Propeller) airplanes.
*Up to 3 conditions can be set.
*The priority increases in condition 1→2→3 order.
NOTE: When VPP is not assigned to any
channel, the pitch curve is not displayed in
the model menu. In this case, assign VPP to
any channel on the function screen.
●Select[PITCURVE]attheModelmenu
and access the setup screen shown
below by pushing the RTN button.
●Curverate
PIT CURVE
[Correspondingmodeltype]:Airplane,general
Setting method
●VPP condition selection
1. Move the cursor to the # button at the top
right side of the screen and push the RTN
button to switch to the data input mode.
 SelecttheVPPconditionbyscrollingthePush
dial.
*The display blinks.
 PushtheRTNbuttontocallthesettingscreen
and return to the cursor mode.
2. Move the cursor to the switch item and
push the RTN button to access the selection
screen.SelecttheswitchandsetitsON
direction.
*For a description of the switch selection method, see the
description at the back of this manual.
 SettheVPPcondition2and3switch.
*The VPP conditions can also be checked in the HOME
screen.
●5-point curve setting
[Curveratesetting]
1. Move the cursor to the curve rate setting
item you want to adjust and push the RTN
button to switch to the data input mode.
 AdjusttheratebyscrollingthePushdial.
 Initialvalue:0%
 Adjustmentrange:0%~100%
*When the RTN button is pushed for one second, the rate is
reset to the initial value.
 PushtheRTNbuttontoendtheadjustment
and return to the cursor mode.
2. Repeat this procedure for each point.
[Movingcurvepoint]
1. Move the cursor to the curve point setting
item you want to adjust and push the RTN
button to switch to the data input mode.
 AdjustthecurvepointbyscrollingthePush
dial.
 Initialvalue:P1:(0%),P2:25%,P3:50%,P4:
75%,P5:(100%)
 Adjustmentrange:Upto2.5%infrontofthe
adjoining point
*When the RTN button is pushed for one second, the curve
position is reset to the initial value.)
 PushtheRTNbuttontoendtheadjustment
and return to the cursor mode.
2. Repeat this procedure for each point.
[Deleting/returningcurvepoint]
Move the cursor to the curve point setting
itemyouwanttodelete/returnandpushthe
RTN button for one second.
●Curvepoint
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Toinputdatamode
●Dataisentered