FUTABA T12K

124
<Functions of Linkage Menu>
●Selectthefunctionname
andreturntotheLinkage
menubypushingthe RTN
buttonor pushingthe
HOME/EXITbutton.
<Push Dial>
RETURN
All the sensors to be used are connected.
SENSOR SENSOR
3-way hub
or Y-harnesses
Receiver's
battery
SENSOR SENSOR SENSOR
Use this function when repeated registration
and deregistration of slots has left open slots
fragmented and unusable. It rearranges them into
contiguous unused slots.
Relocate of sensors to be used
1.Connectallthesensorsandreceiver
batteriestobeusedtotheT12Kthrougha
hubasshowninthegureabove.
2.Movethecursorto“RELOCATE”onpage7of
the[SENSOR]screen.
3.PushtheRTNbutton.
This procedure changes the slot number of one
registered sensor.
Sensor slot change
1.Connectthesensorandreceiverbatteryto
bechangedtotheT12Kthroughahubas
showninthegureabove.
2.Movethecursorto“SETSLOT”onpage7of
the<Sensor>screen.
3.PushtheRTNbutton.Asensordetailsscreen
appears.
4.Movethecursorto“LOAD”andpushtheRTN
button.
5.Thecurrentstartslotisdisplayed.Movethe
cursortothenumberofthestartslotand
changeittothedesiredvalue.
（
Cannotbe
settoaslotthatcannotbeallocatedlikethe
tableofallpages.
）
6.Movethecursorto“WRITE”andpushtheRTN
button.
SENSOR : RELOCATE
SENSOR : SET SLOT
3-way hub
or Y-harnesses
Receivers
battery
SENSOR
Follow these instructions when using multiple telemetry sensors of the same type.
This page is for using multiple telemetry sensors of the same type.
●Callpage7bypushingtheS1button6timesfrom
the[SENSOR]menu.
Scrolling
●Movingcursor
●Tonextpage
●Dataisentered