FUTABA T12K

105
<Functions of Linkage Menu>
●Selectthefunctionname
andreturntotheLinkage
menubypushingthe RTN
buttonor pushingthe
HOME/EXITbutton.
<Push Dial>
RETURN
TELEMETRY : EXT-VOLT
DisplayingdatafromtheEXTbatteryvoltageport
The EXT-VOLT screen will display the data from
the EXT-battery output from the R3008SB receiver.
In order to use this function, it is necessary to
connect external voltage connector of the R3008SB
receiver to a CA-RVIN-700 (FUTM5551) or
SBS-01V to the battery you desire to measure the
voltage of.
You will be alerted by an alarm or vibration if
the voltage set by you is exceeded.
*It cannot be used in S-FHSS mode
●Select[EXT-VOLT]intheTELEMETRYscreenand
accessthesetupscreenshownbelowbypushing
theRTNbutton.
●EXTbatteryvoltage
●Themaximumandtheminimumwhen
poweringONareshown.
●↓Thearrowwillindicatethat
analarmwillsoundwhen
thevoltagedropstobelow
thesetting.
Alert set
1.Movethecursortothe↓ALERT[INH]itemand
pushtheRTNbuttontoswitchtothedata
inputmode.
2.SelecttheACTmodebyscrollingthePush
dial.
3.PushtheRTNbutton.(Toterminatetheinput
andreturntotheoriginalstate,pushtheS1
button.)
4.Movethecursortothe↓THRESHOLD[4.0V]
itemandpushtheRTNbuttontoswitchto
thedatainputmode.
5.AdjusttheratebyscrollingthePushdial.
 Initialvalue:4.0V
 Adjustmentrange:0.0V~100.0V
*When the RTN button is pushed for one second, the rate is
reset to the initial value.
6.PushtheRTNbutton.(Toterminatetheinput
andreturntotheoriginalstate,pushtheS1
button.)
TYPE 1
TYPE 2
TYPE 3
TYPE 4
"Vibes" type
Ifthefollowingtypesareselected,thetransmitterwill
vibrateduringthewarning.
*CA-RVIN-700 or SBS-01V must be installed in the aircraft.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage
●Toinputdatamode
●Dataisentered