FUTABA T12K

157
<Model Menu (Airplane/Glider/Multirotor Functions)>
●Selectthefunctionname
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
<Push Dial>
RETURN
AIRBRAKE
[Correspondingmodeltype]:Airplane,2aileronsormore
This function is used to increase the aircraft's
drag and is useful for landing or diving, etc.
The preset ailerons, elevators, rudder and aps
(camber flap, brake flap) offset amount can be
activated by a switch.
The offset amount of the aileron, elevator,
rudder and ap servos can be adjusted as needed.
Also, the speed of the aileron, elevator, rudder
and ap servos can be adjusted. If the Auto Mode
is activated, this will link the Airbrake to a stick,
switch, or dial. A separate stick switch or dial can
also be set as the ON/OFF switch.
Setting example for F3A and other aperon specications
(When2aileronsmodeltypeselected)
Offsetrate:
 AIL:[-35~-45%],AIL2:[-35~-45%],ELE:[+5~7%]
Note: The input numerics are examples. Adjust the travel to
match the aircraft.
Mode setting:
 ACT:[ON]
 Switch:[SW-C]
 AUTO-SW:[--]
●Select[AIRBRAKE]attheModelmenuandaccess
the setup screen shown below by pushing the RTN
button.
*The display screen is an example. The
actual screen depends on the model type.
●Ailerons,flaps,rudder
and elevators servo
speed setting
●Autoswitchselection
●Ailerons,flaps,rudderand
elevators offset rate
●Switch
selection
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage
●Toinputdatamode
●Dataisentered