Operation direction reversal method
1. Select [H/W REVERSE] and access the setup
screen shown below by pushing the RTN
button.
2. Move the cursor to the item corresponding to
the H/W (hardware) you want to reverse and
push the RTN button to switch to the data
input mode.
3. Select the mode by scrolling the Push dial.
The display blinks. When the RTN button is
pushed, the operation direction is reversed.
(To terminate the mode change, push the S1
button.)
"NORM": Normal operation direction
"REV" : Operation direction is reversed.
H/W SETTING
Hardware reverse and stick mode
H/W reverse
This function reverses the operation direction of
the sticks, switches, trim levers, and knobs.
Note: This setting reverses the actual operation
signal, but does not change the display
indicators. Use the Normal mode as long as
there is no special reason to use the Reverse
mode.
Stick mode
This function changes the stick mode of
transmitter.
Note: This will not change the throttle ratchet,
etc. Mechanical changes must be performed
by a Futaba service center.
Note: After changing the mode, these changes
are only applied to new models. It is not
applied to an existing model.
Stick calibration
J1-J4 stick correction can be performed.
● Select [H/W SET] at the system menu and access
the setup screen shown below by pushing the RTN
button.
Changing stick mode
1.Select [STICK MODE] and access the setup
screen shown below by pushing the RTN
button.
2. Move the cursor to the "STICK MODE" item
and push the RTN button to switch to the
data input mode.
3. Select the mode. The display blinks. When
the RTN button is pushed, the stick mode is
changed. (To terminate the mode change,
push the S1 button.)
(J1)
To Next Page
Loading...
