FUTABA T12K

143
<Model Menu (Airplane/Glider/Multirotor Functions)>
●Selectthefunctionname
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
<Push Dial>
RETURN
AIL 3
(Chip Aileron)
AIL 4
(Chip Aileron)
AIL1
(Main Aileron)
AIL 2
(Main Aileron)
FLP 2
(Camber Flap)
FLP 1
(Camber Flap)
AIL to CMBFLP
[Correspondingmodeltype]:Airplane/glider,2ailerons+2apsor
more
This mix operates the camber flaps (FLP1/2)
in the aileron mode. When the aileron stick
is manipulated, the ailerons and camber flaps
perform aileron operation simultaneously to
signicantly improve the roll axis.
●Theaileronleft/rightmixingrateofeachapservo
can be independently adjusted.
●AnON/OFFswitchcanbeset.
●Linkingispossible:Linkthismixtoothermixes.
●Adjustmentofeach
apservo
Setting method
●Activate the function
 Movethecursortothe[ACT]itemandpush
the RTN button to switch to the data input
mode.SelecttheACTmodebyscrollingthe
Pushdial.
*The display blinks.
 PushtheRTNbuttontoactivatethefunction
andreturntothecursormode.(ONis
displayed.)
When selecting a switch, move the cursor to
the[SW]itemandpushtheRTNbuttontocall
theselectionscreen.Selecttheswitchand
setitsONdirection.(AlwaysONat"--"setting)
*For a description of the switch selection method, see the
description at the back of this manual.
●Mixing rate adjustment
 Movethecursortotheflap(FLP)1~2left
or right item according to the wing type
and push the RTN button to switch to the
datainputmode.Adjustthemixingrate
independentlybyscrollingthePushdial.
 Initialvalue:0%
 Adjustmentrange:-120~+120%
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
 PushtheRTNbuttontoendtheadjustment
and return to the cursor mode.
●Link mode setting
When linking a mix, move the cursor to the
[LINK]itemandpushtheRTNbuttontoswitch
tothedatainputmode.SelecttheONmode
byscrollingthePushdial.
*The display blinks.
 PushtheRTNbuttontosetthelinkmodeand
return to the cursor mode.
●Select[AILtoCMBFLP]attheModel
menu and access the setup screen
shown below by pushing the RTN
button.
*The display screen is an example. The actual
screen depends on the model type.
(Glider: Currently selected condition name)
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Toinputdatamode
●Dataisentered