TRAINER
Trainer system starting and setting
T12K trainer system makes it possible for the
instructor to chose which channels and operation
modes can be used in the student transmitter.
The function and rate of each channel can be
set. The training method can also be matched to
the student's skill level. Two transmitters must
be connected by an optional Trainer Cord. The
instructor's transmitter should be programmed for
trainer operation, as described below.
When the instructor activates the trainer switch,
the student has control of the aircraft (if MIX/
FUNC/NORM mode is turned on, the Instructor
can make corrections while the student has control).
When the switch is released, the instructor regains
control. This is very useful if the student gets the
aircraft into an undesirable situation.
● Setting data are stored to model data.
● Student rate can be adjusted at MIX/FUNC/
NORM mode.
● Activated student channels can be selected
by switches.
NOTE: This trainer system can be used in the
following ways:
1. With the T12K and a conventional transmitter,
you must match the channel order on the
two transmitters before using the trainer
function.
You can select the channel of input data
from the student transmitter in the "FUNC" or
"MIX" mode.
2. When the T12K is used as the instructor
transmitter, set the modulation mode of the
student’s transmitter to PPM.
If used as the student, T12K can be connected
to the instructor transmitter, which must be set
to PPM mode. T12K always uses the PPM mode
to send or receive signals through the trainer
jack.
(In the case of non-2.4GHz student transmitters.)
3. Be sure that all channels work correctly in
both transmitters before ying.
Corresponding types of transmitters and trainer mode settings:
Types of transmitters
Instructor's transmitter settings Student's transmitter settings
System Type Trainer setting System Type Trainer setting Trainer Cords
Instructor Student Mod. mode CH mode Mod. mode CH mode Mod. mode
T12K/T14SG/
T16SZ/T18SZ/
T18MZ
T12K/T14SG/
T16SZ/T18SZ/
T18MZ
Arbitrary 16CH Arbitrary 16CH -
T12FG (FUTM4405)
and 9C (FUTM4415)
Trainer Cords
T12K
T14MZ, FX-40,
T12Z, T12FG,
FX-30
Arbitrary 12CH
PCM-G3
2.4G
12CH PPM
T12K T8FG, FX-20 Arbitrary
12CH FASST-MLT2
- -
8CH FASST-MULT
T12K
T10C, T9C,
T7C,T6EX,
T4EX
Arbitrary 8CH PPM - - T12FG (FUTM4405)
T12K T10CG,T7C Arbitrary 8CH Arbitrary - - T12FG (FUTM4405)
T12K T8J,T6K,T6J Arbitrary 8CH Arbitrary - -
T12FG (FUTM4405)
and 9C (FUTM4415)
Trainer Cords
T14MZ, FX-40,
T12Z, T12FG,
FX-30
T12K Arbitrary 12CH Arbitrary 12CH -
T8FG, FX-20 T12K Arbitrary 12CH Arbitrary 12CH -
T10C, T10CG,
T9C, T7C,
T7C,T8J,T6K,
T6J
T12K Arbitrary - Arbitrary 8CH -
To Next Page
Loading...
