FUTABA T12K

129
<Model Menu (Common Functions)>
●Selectthefunctionname
andreturntotheModel
menubypushingthe RTN
buttonor pushingthe
HOME/EXITbutton.
<Push Dial>
RETURN
DUAL RATE
Theangleandcurveofeachstickfunctioncanbeset.[Allmodeltypes]
Dual rate function is used to adjust the amount
of throw and the operational curve of the stick
functions (aileron, elevator and rudder) for each
ight condition or up to 5 rates for each function.
For airplane type, it is also possible to adjust the
operational curve of the throttle function.
This is normally used after the End Point
programming has been completed to define the
maximum throw. When mixing is applied from one
channel to another channel, both channels can be
adjusted at the same time by adjusting the operation
rate through the dual rate function.
Neutral position of the dual rate curve can be
set.
Dual rate curve of FLAP, FLAP3, BUTTERFLY,
and CAMBER function can be set. (Airplane/
Glider)
*FLAP3 and BUTTERFLY are glider only functions.
*EXP rate setting is not allowed in the FLAP, FLAP3,
BUTTERFLY, and CAMBER functions.
*Individual switch setting is not allowed in the FLAP,
FLAP3, and BUTTERFLY, CAMBER functions. (Condition
switching only)
●Select[DUALRATE]attheModelmenuand
accessthesetupscreenshownbelowbypushing
theRTNbutton.
(Currently selected circuit #)
●Neutralposition
●Left/right(up/down)rate
●Operationcurve(left/right,up/down)
●Switchselection
[Airplane]
[Helicopter/glider]
●ConditionMode
selection
●Switchmode
selection
●Conditionselection
●Switchselection
*Up to ve rates for each function
●Functionselection
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage
●Toinputdatamode
●Dataisentered