FUTABA T12K

130
<Model Menu (Common Functions)>
Dual rate setting procedure
1.Functionselection
 Movethecursortothefunctionselection
itemandpushtheRTNbuttontoswitchto
thedatainputmode.
 Selectthefunctionyouwanttoadjustby
scrollingthePushdial.
 PushtheRTNbuttontothecursormode.
2.Switchselection
 Movethecursortothecircuit#itemand
accesstheswitchsetupscreenbypushing
theRTNbutton.Selecttheswitchactivation
methodandtheactivationposition(if
applicable).
*For a detailed description of the setting method, see [Switch
Setting Method] at the back of this manual.
3.Left/right(up/down)rateadjustment
*Perform the settings below after changing to the circuit # or
condition you want to adjust.
 Movethecursortotherateitemyouwantto
adjustandpushtheRTNbuttontoswitchto
thedatainputmode.
 AdjusttheratebyscrollingthePushdial.
 Initialvalue:100%
 Adjustmentrange:0%~140%
*When the RTN button is pushed for one second, the servo
operation position is reset to the initial value.)
 PushtheRTNbuttontoendtheadjustment
andreturntothecursormode.
 Repeatthisprocedureforadditionalrate
andotherfunctionsasdesired.
4.Operationcurve(EXPcurve)adjustment
*Perform the settings below after changing to the circuit # or
condition you want to adjust.
 MovethecursortotheEXPitemyouwantto
adjustandpushtheRTNbuttontoswitchto
thedatainputmode.
 AdjusttheratebyscrollingthePushdial.
 Initialvalue:0%
 Adjustmentrange:-100%~+100%
*When the RTN button is pushed for one second, the servo
operation position is reset to the initial value.)
*Using the EXP curve is effective to smooth or soften the
control inputs around center to avoid over-controlling the
model. This is often used for the ailerons, elevator and
rudder and may be used with the throttle in the case of an
airplane selection to smooth the engine controls as well.
 PushtheRTNbuttontoendadjustmentand
returntothecursormode.
 Repeatthisprocedureforallotherratesand
functionsasdesired.
5.Neutralpositionadjustment
*Perform the settings below after changing to the circuit # or
condition you want to adjust.
 Movethecursortothe[NT]itemandpush
theRTNbuttontoswitchtothedatainput
mode.
 AdjusttheratebyscrollingthePushdial.
 Initialvalue:0%
 Adjustmentrange:-100%~+100%
*When the RTN button is pushed for one second, the neutral
position is reset to the initial value.)
 PushtheRTNbuttontothecursormode.