FUTABA T12K

138
<Model Menu (Airplane/Glider/Multirotor Functions)>
●Selectthefunctionname
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
<Push Dial>
RETURN
This function adjusts the throttle curve for
optimum engine speed from throttle stick input.
*When throttle curve is set to ON when there is no throttle
function; this curve acts as the motor function.
NOTE: If this throttle curve function is activated,
you cannot use the THR-EXP function within
the DUAL RATE function simultaneously.
●Select[THRCURVE]attheModelmenu
and access the setup screen shown
below by pushing the RTN button.
●Curverate
THR CURVE
Setting method
●Activate the function.
1.Movethecursortothe[ACT]itemandpush
the RTN button to switch to the data input
mode.
 SelecttheONmodebyscrollingthePush
dial.
*The display blinks.
 PushtheRTNbuttontoactivatethefunction
and return to the cursor mode.
●5-point curve setting
[Curveratesetting]
1. Move the cursor to the curve rate setting
item you want to adjust and push the RTN
button to switch to the data input mode.
 AdjusttheratebyscrollingthePushdial.
 Initialvalue:0%
 Adjustmentrange:0%~100%
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
 PushtheRTNbuttontoendtheadjustment
and return to the cursor mode.
2. Repeat this procedure for each point.
[Movingcurvepoint]
1. Move the cursor to the curve point setting
item you want to adjust and push the RTN
button to switch to the data input mode.
 AdjustthecurvepointbyscrollingthePush
dial.
 Initialvalue:P1:(0%),P2:25%,P3:50%,P4:
75%,P5:(100%)
 Adjustmentrange:Upto2.5%infrontofthe
adjoining point
*When the RTN button is pushed for one second, the curve
position is reset to the initial value.)
 PushtheRTNbuttontoendtheadjustment
and return to the cursor mode.
2. Repeat this procedure for each point.
[Deleting/returningcurvepoint]
Move the cursor to the curve point setting
itemyouwanttodelete/returnandpushthe
RTN button for one second.
●Curvepoint
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage
●Toinputdatamode
●Dataisentered
[Correspondingmodeltype]:Airplane/glider/Multirotor,general