FUTABA T12K

166
<Model Menu (Airplane/Glider/Multirotor Functions)>
●Selectthefunctionname
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
<Push Dial>
RETURN
RUD to ELE
[Correspondingmodeltype]:Airplane,general
This function is used when you want to mix
elevator operation with rudder operation. It is used
to correct undesirable tendencies when rudder is
applied in rolling maneuvers such as knife edge
ight.
●MixingduringflightcanbeturnedON/OFFby
settingaswitch.(AlwaysONat[--]setting)
●Linkmixingcanbeset:Linksthismixtoothermixes.
●Select[RUDtoELE]attheModel
menu and access the setup screen
shown below by pushing the RTN
button.
Setting method
●Activate the function
 Movethecursortothe[ACT]itemandpush
the RTN button to switch to the data input
mode.SelecttheACTmodebyscrollingthe
Pushdial.
*The display blinks.
 PushtheRTNbuttontoactivatethefunction
andreturntothecursormode.(ONis
displayed.)
When selecting a switch, move the cursor to
the[SW]itemandpushtheRTNbuttontocall
theselectionscreen.Selecttheswitchand
setitsONdirection.(AlwaysONat"--"setting)
*For a description of the switch selection method, see the
description at the back of this manual.
●5-point curve setting (airplane)
[Curveratesetting]
1. Move the cursor to the curve rate setting
item(leftside)youwanttoadjustandpush
the RTN button to switch to the data input
mode.
 AdjusttheratebyscrollingthePushdial.
 Adjustmentrange:-100%~+100%
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
 PushtheRTNbuttontoendtheadjustment
and return to the cursor mode.
2. Repeat this procedure for each point.
[Movingcurvepoint]
1. Move the cursor to the curve point setting
item you want to adjust and push the RTN
button to switch to the data input mode.
 AdjustthecurvepointbyscrollingthePush
dial.
 Adjustmentrange:Upto2.5%infrontofthe
adjoining point
*When the RTN button is pushed for one second, the curve
position is reset to the initial value.)
 PushtheRTNbuttontoendtheadjustment
and return to the cursor mode.
2. Repeat this procedure for each point.
[Deleting/returningcurvepoint]
Move the cursor to the curve point setting
itemyouwanttodelete/returnandpushthe
RTN button for one second.
●Link mode setting
When selecting the link mixing, move the
cursortothe[LINK]itemandpushtheRTN
button to switch to the data input mode.
SelecttheONmodebyscrollingthePush
dial.
*The display blinks.
 PushtheRTNbuttontosetthelinkmodeand
return to the cursor mode.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Toinputdatamode
●Dataisentered