FUTABA T12K

179
<Functions of Model Menu (Helicopter Functions)>
●Selectthefunctionname
andreturntotheModel
menubypushingthe RTN
buttonor pushingthe
HOME/EXITbutton.
<Push Dial>
RETURN
THROTTLE MIX
This function corrects the slowing of engine
speed caused by swash plate operation during
aileron or elevator operation. The method of
applying clockwise or counterclockwise torque
when pirouetting can also be corrected.
Setting example
●AILtoTHRmixingcounteractsthelaginthe
engineRPM'swhenaileroninputisgiven
tothehelicopter.Engineover-speeding
canbeadjustedindependentlyforthe
rightaileronandleftaileroninputsutilizing
Rates1and2.
●Select[THROTTLEMIX]attheModelmenuand
accessthesetupscreenshownbelowbypushing
theRTNbutton.
(Currently selected condition name)
Setting method
●Activate the mixing
 Whenusingthisfunction,movethecursorto
the[ACT]itemandpushtheRTNbuttonto
switchtothedatainputmode.
 SelecttheACTmodebyscrollingthePush
dial.
*The display blinks.
 PushtheRTNbuttontoactivatethemixing
andreturntothecursormode.(ONis
displayed.)
 [Switchselection]
 When[[--]]isset,theswashmixingfunction
isalwaysactiveandoperatedbymerely
selectingthecondition.
 Whensettingan[ON]/[OFF]switch,move
thecursortothe[SW]itemandpushtheRTN
buttontocalltheselectionscreen.Setthe
switchanditsONposition.
*For a description of the switch selection method, see the
description at the back of this manual.
●Mixing rate adjustment
 Movethecursortothemixingrateitemyou
wanttocorrectandpushtheRTNbuttonto
switchtothedatainputmode.Adjustthe
rateindependentlybyscrollingthePushdial.
 Initialvalue:0%
 Adjustmentrange:-100~+100%
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
 PushtheRTNbuttontoendtheadjustment
andreturntothecursormode.
●Operation mode setting
 Movethecursortothe[MODE]itemand
pushtheRTNbuttontoswitchtothedata
inputmode.
 Selecttheoperationmodebyscrollingthe
Pushdial.
*The display blinks.
 CTRMmode:Correctsnearthecenteronly.
 LIN.mode:Correctsthecompleterange.
 PushtheRTNbuttontochangetheoperation
modeandreturntothecursormode.
●Conditionselection
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage
●Toinputdatamode
●Dataisentered