FUTABA T12K

167
<Model Menu (Airplane/Glider/Multirotor Functions)>
●Selectthefunctionname
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
<Push Dial>
RETURN
SNAP ROLL
[Correspondingmodeltype]:Airplane,general
This function selects the switch and rate
adjustment of ailerons, elevators, and rudder when
a snap roll is performed.
●Foursnaprolldirectionscanbeset.(Right/up,
right/down,left/up,left/down)
●Operationmode:When[Master]modeisselected,
theSnapRollfunctionisturnedON/OFFbythe
masterswitch.Itispossibletosetthedirection
switch to the direction in which you want to snap
roll.When[Single]modeisselected,thesnaproll
in each direction can be executed by means of
independent switches and positions.
●Asafetyswitchcanbesettopreventthe
accidentalactivationofthesnaproll.For
example, the landing gear is lowered, even if
the switch is turned on accidentally the snap roll
would not be executed. The snap roll switch is
activatedonlywhenthesafetyswitchisOFF.
(Example) Setting example for F3A
●Mode:[Master]
●SafetySW:[SG](Safetymeasure)
●MasterSW:[SH](Mainswitchforexecuting
snaproll)
●Directionswitches:
*The snap roll up side left and right and down side left and right
direction switches are selected here.
Right/Up:OFF[SD]
Right/Down:OFF[SD]
Left/Up:OFF[SA]
Left/Down:OFF[SA]
●Master/singlemode
selection
●Select[SNAPROLL]attheModelmenu
and access the setup screen shown
below by pushing the RTN button.
●Directionswitches
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage
●Toinputdatamode
●Dataisentered