LCD contrast adjustment
1. Select "CONTRAST" and push the RTN button
to switch to the data input mode and adjust
the contrast by scrolling the Push dial.
"CONTRAST": Adjust the contrast to the
desired value while watching the screen
display.
Setting range: (Lighter) 0 to 15 (Darker)
Initial value: 5
*When you want to reset the value to the initial state, push
the RTN button for one second.
2. Push the RTN button to end adjustment and
return to the cursor mode.
Backlight brightness adjustment
1. Select "BRIGHTNESS" and push the RTN button
to switch to the data input mode and adjust
the backlight brightness by scrolling the Push
dial.
"BRIGHTNESS": Adjust the brightness to the
desired value while watching the screen
display.
Setting range: OFF, 1 to 20(Lighter)
Initial value: 10
*When you want to reset the value to the initial state, push
the RTN button for one second.
DISPLAY
LCD and backlight adjustment, unit system
LCD contrast, backlight brightness, and
backlight off timer adjustment are possible.
You can also set your units to either the metric
system or standard.
2. Push the RTN button to end adjustment and
return to the cursor mode.
Back-light off-timer
1. Select "OFF TIMER" and push the RTN button
to switch to the data input mode and adjust
the backlight off timer by scrolling the Push
dial.
"OFF TIMER": Adjust the time when the
backlight turns off after operating the Push
dial.
Setting range: 10 to 240 sec (each 10 sec),
OFF (always on)
Initial value: 10 sec
*When you want to reset the value to the initial state, push
the RTN button for one second.
2. Push the RTN button to end adjustment and
return to the cursor mode.
Unit system adjustment
1. Select "UNIT SYS." and push the RTN button
to switch to the data input mode and adjust
the unit by scrolling the Push dial.
Setting range: (METRIC) or (YARD/POUND)
2. Push the RTN button to end adjustment and
return to the cursor mode.
● Select [DISPLAY] at the system menu and access
the setup screen shown below by pushing the RTN
button.
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To input data mode
● Data is entered
To Next Page
Loading...
