Adjusting the student's rate.
*This can be adjusted for students who may need lower rates
than a more experienced student.
1. Move the cursor to the [RATE] item of the
channel you want to change and push the
RTN button to switch to the data input mode.
2. Adjust the rate by scrolling the Push dial.
"RATE": Adjust the desired rate.
Setting range: 0~100%
Initial value: 100%
*When you want to reset the value to the initial state, push
the RTN button for one second.
3. To end adjustment, push the RTN button and
return to the cursor mode.
Changing the student's channel
*The setting above allows setting of the channel assignment
of student side when [MIX] or [FUNC] was selected.
1. Move the cursor to the [STU. CH] item of the
channel you want to change and push the
RTN button to switch to the data input mode.
2. Select the channel by scrolling the Push
dial. The display blinks. Push the RTN button
to change the channel. (To terminate the
mode change, push the S1 button.)
"STU. CH": Match the channel order of the
Instructor's and student's transmitter. This
function will help if both transmitters are in
different modes, or the Master has a different
wing type set up. The student can be set
to match the Master without any physical
changes being made.
In case of MULTIROTOR type
■The default settings of TRAINER at
MULTIROTOR are below. It is easy to set
TRAINER when the student radio is used for
camera gimbal control.
*Please do not use REVERSE, END POINT, or any other
mixes at student transmitter.
To Next Page
Loading...
